Avery-dennison A64 CS Stacker Manual do Utilizador descarregar pdf (Página 6)

About the Menu Overview

The stacker has three mode menus shown below.

Press the MODE key to navigate through the main menu and display each mode.

Press START/STOP to select a mode. Use the ARROW keys to select options within a mode.

Mode Selection Customize Modes Service & Diagnostics

1. Standard Notch 1. Standard Cut Master Cutline Adjustment

2. 1.222 Swiftach 2. 1.222 Swiftach Sensor Status

3. 1.250 Swiftach 3. 1.250 Swiftach Cycle Count

4. 1.375 Swiftach 4. 1.375 Swiftach Reset to Factory Defaults

5. User defined 5. User defined Motor Tests

6. User defined 6. User defined Web Test

7. User defined 7. User defined Knife Motor Test

8. User defined 8. User defined Transport Motor Test

9. User defined 9. User defines Pusher Motor Test

10. User defined 10. User defined Check LCD

Check Keypad

Check Memory

For each specify: For each specify: Sensor Trip Points

Flags? YES/NO/EXT Sensor Type: Transmissive Sensor Adjust

Transmissive Reflective Sensor Adjust

Reflective Flag Sensor Adjust

Offset: mm LCD Contrast Adjustment

Speed Setup

Note: Modes 5 through 10 display in Mode Selection only after they are defined in the

Customize Modes menu.

1 2 3 4 5 6 7 8

Sem comentários

Avery-dennison A64 CS Stacker Manual do Utilizador Página 6