Avery-dennison Monarch 932 Stacker Manual do Utilizador

©2004 Avery Dennison Corp. All rights reserved. 28028 28028 0 0 Operating InstructionsTC932OI Rev. AE 11/09 ®Monarch 932™Stacker 3 625498710gTlinc

5. Move the tag stop up and down by using your thumb to pull out slightlyon the release tab and lift up until it stops.Note: Adjust the tag stop to th

Step 5 - Set the Tag Width1. Set aside the tag.2. Locate the tag weight.3. Unlock the tag weight handle by turning the knobcounterclockwise.4. Determi

6. Place the tag weight against the tag stop.7. Print a test batch of 50 tags. The stacker’s LED is on when tags aremoving through the stacker.Step 6

3. Turn the belt adjustment knob to the number from the stack.4. Print another test batch of 50 tags or more. The stacker’s LED is on when tags are mo

1-10 Getting Started

USING THE STACKER 2This chapter describes how to ¨re-load and change supplies¨empty the stacker tray¨clear a tag jam¨install verifier riser blocksUsin

Re-Loading or Changing SuppliesIf you run out of supplies while printing, the printer display or keyboardshows a 756 status code.1. Press Feed to feed

Clearing a Tag JamIf a tag jams inside the stacker, the printer and stacker automatically stop. The printer display or keyboard shows a 761 status cod

3. Use the tab to lift the transport. Check for tags.4.Remove the tags.5. Lower the transport.6. Replace the transport lock handle. Make sure it is

TROUBLESHOOTING 3This section helps you correct some problems that may occur.Problem ActionStacker Full or 760Warning StatusCode1. Empty the stacker t

Each product and program carries a respective written warranty, the onlywarranty on which the customer can rely. Avery Dennison Corp. reservesthe rig

3-2 Getting Started

SPECIFICATIONS AStackerHeight: 14.4 inches (366 mm)Width: 7.9 inches (201 mm)Length: 29.6 inches long (752 mm)Tag Bed: 23.5 inches long (597 mm)Weight

Supplies Thickness: .007 inches (.18 mm) minimum.010 inches (.25 mm) maximumWidths: 1.2 inch (30 mm) minimum 4.0 inches (102 mm) maximumLengths: 1.2 i

28028 28028 0 0 Avery Dennison Printer Systems Division170 Monarch LaneMiamisburg, OH 453421-800-543-6650 (In the U.S.A.)1-800-387-4740 (In Canada)w

TABLE OF CONTENTSGETTING STARTED...1-1Unpacking the Stacker ...

ii Table of Contents

GETTING STARTED 1The Monarch® 932ä stacker works with a Monarch® 9860äprinter. The stacker supports backfeed mode on the printer. Thereis no power ON/

Step 1 - Connect the Stacker1. Locate the screw hole on the stacker mounting plate.2. Attach the adjusting bracket to the stacker mounting plate using

Step 2 - Level the Stacker1. Check the distance between the rollers and the knife. Makesure the rollers are not touching the front of the knife or to

Step 3 - Connect the Power Cord1. Plug the power cord into the stacker’s AC inlet.2. Plug the other end of the power cord into a grounded outlet.Once

Step 4 - Check the Alignment1. Load supply in the printer. For more information aboutloading supply, refer to the printer’s Operator’s Handbook orQui